All Collections
For Swim Admins
TouchPad: Meet Timeline / Duration reports
TouchPad: Meet Timeline / Duration reports
Updated over a week ago

SwimOffice Admin - TouchPad PC

You can get an estimate of how long the meet will run with either the Meet Timeline report or the Meet Duration report. The former allows you to specify a scratch factor to see what the timeline will look like if you scratch a percentage of the slowest kids. This only applies to unseeded events. The latter allows you to specify an event range. Otherwise, they are identical.

Meet Timeline report

If the timeline is too long for a given session, use the Apply Scratch Factor to unseeded events to view how much the timeline will change.

  1. Click Meet Reports.

  2. Select Meet Timeline on left.

  3. Enter a scratch factor percentage on the right.

  4. Select any other desired options.

  5. Click Print/Preview.

The Number in the Event column will show (SF) by it to indicate it’s a scratch factor. The number represents the number of swimmers remaining after scratching the slowest ones by the percentage entered, and the start and finish times reflect those numbers as well. This only applies to unseeded events.

Meet Duration report

  1. Click Heat Sheets.

  2. Select Meet Duration on the left.

  3. Select your Active Session if desired (your timeline will base its calculations on your sequence setup), or enter an event number range on the right.

  4. Click Print/Preview.

Did this answer your question?